19-08-2012, 19:42 PM
Tyhikäigu reguleerimine ke-jetronic pritsega masinatel:
10.27 Idle speed adjustment screw (arrowed) on KE-Jetronic system
28 Before making any adjustments, warm the engine up to normal operating temperature and connect a tachometer in accordance with the manufacturer’s instructions.
29 Disconnect the wiring multi-plug at the pressure actuator on the side of the fuel distributor (see illustration).
![[Pilt: 011.gif]](http://www.fordmanuals.org/images/books/936/pages/01/011.gif)
10.29 Pressure actuator wiring multi-plug (arrowed) - KE-Jetronic system
30 Increase the engine speed to 3000 rpm and hold it at this speed for 30 seconds, then allow the engine to idle. Check the tachometer reading and if necessary turn the idle speed adjustment screw as required until the engine is idling at the specified speed.
31 To check the mixture adjustment an exhaust gas analyser is needed and should be connected in accordance with the manufacturer’s instructions. A 3 mm Allen key will also be required to make any adjustments.
32 Before proceeding ensure that the idle speed is correct.
33 Unscrew the tamperproof plug from the mixture adjustment orifice on top of the fuel distributor (see illustration).
Seega kuna tyhikäiku reguleeritakse juhe tagant t6mmatuna peab see systeem töötama ilma ajuta?
Vaatsin , et jagajal pole vaakumiga syyte reguleerimist ,siis kysin , millega seda syydet reguleeritakse , kas see tuleb ajust või on miskine eriline kommutaator.
10.27 Idle speed adjustment screw (arrowed) on KE-Jetronic system
28 Before making any adjustments, warm the engine up to normal operating temperature and connect a tachometer in accordance with the manufacturer’s instructions.
29 Disconnect the wiring multi-plug at the pressure actuator on the side of the fuel distributor (see illustration).
10.29 Pressure actuator wiring multi-plug (arrowed) - KE-Jetronic system
30 Increase the engine speed to 3000 rpm and hold it at this speed for 30 seconds, then allow the engine to idle. Check the tachometer reading and if necessary turn the idle speed adjustment screw as required until the engine is idling at the specified speed.
31 To check the mixture adjustment an exhaust gas analyser is needed and should be connected in accordance with the manufacturer’s instructions. A 3 mm Allen key will also be required to make any adjustments.
32 Before proceeding ensure that the idle speed is correct.
33 Unscrew the tamperproof plug from the mixture adjustment orifice on top of the fuel distributor (see illustration).
Seega kuna tyhikäiku reguleeritakse juhe tagant t6mmatuna peab see systeem töötama ilma ajuta?
Vaatsin , et jagajal pole vaakumiga syyte reguleerimist ,siis kysin , millega seda syydet reguleeritakse , kas see tuleb ajust või on miskine eriline kommutaator.
Pole midagi targemat teha