29-11-2007, 12:21 PM
Tsiteerin Emot-it:
I find KTM length 132mm ,with 24mm bigend pin (you need to put steel bushings in the crankshaft. This one is 17mm wide.
And I find Sea Doo (Rotax) 140mm length ,with 28mm pin ,which means you must have a 29x28x29mm pin made to fit it.
(wiggle the bearing over the thick part of the pin ,it works - i did it before.)
this one is 18mm wide and has a 24mm pistonpin hole ,which means you must use loose 3mm needles to use a 18mm pin.
Tundub, et teine variant oleks nagu teostatavam.
Silindril tuleb sel juhul alt 10mm maha freesida
I find KTM length 132mm ,with 24mm bigend pin (you need to put steel bushings in the crankshaft. This one is 17mm wide.
And I find Sea Doo (Rotax) 140mm length ,with 28mm pin ,which means you must have a 29x28x29mm pin made to fit it.
(wiggle the bearing over the thick part of the pin ,it works - i did it before.)
this one is 18mm wide and has a 24mm pistonpin hole ,which means you must use loose 3mm needles to use a 18mm pin.
Tundub, et teine variant oleks nagu teostatavam.
Silindril tuleb sel juhul alt 10mm maha freesida