19-11-2010, 21:56 PM
Mis programmiga neid pinnamudeli faile saab teha. 3d joonis on Autocadis tehtud. Kas annab salvestada seda ümber?
CNC freespink
« Järgmine vanem | Järgmine uuem »
Sõnumeid selles teemas
CNC freespink - Autor: svenson - 08-01-2010, 23:57 PM
RE: CNC freespink - Autor: metsakohin - 09-01-2010, 01:30 AM
RE: CNC freespink - Autor: Jesper - 18-01-2010, 12:39 PM
RE: CNC freespink - Autor: indrek - 18-01-2010, 13:09 PM
RE: CNC freespink - Autor: Jesper - 18-01-2010, 13:21 PM
RE: CNC freespink - Autor: indrek - 18-01-2010, 13:25 PM
RE: CNC freespink - Autor: Jesper - 18-01-2010, 13:56 PM
RE: CNC freespink - Autor: metsakohin - 13-02-2010, 00:00 AM
RE: CNC freespink - Autor: ifffff - 14-02-2010, 16:11 PM
RE: CNC freespink - Autor: Jesper - 15-02-2010, 00:43 AM
RE: CNC freespink - Autor: ifffff - 15-02-2010, 03:25 AM
RE: CNC freespink - Autor: Ranno - 19-11-2010, 21:56 PM
Kasutaja, kes vaatavad seda teemat: 1 külali(st)ne